Resolving Error Code 223 on Your Lennox® Furnace

Getting cold because you’re noticing error code 223 from your Lennox® furnace?

This is telling you your furnace’s low pressure switch is open. Due to the failure, your system will not work for safety reasons.

Turn to the Experts at Winnipeg Supply Service Experts to deal with mending this furnace error. Our ACE-certified technicians are among the best in the industry when it comes to recognizing and repairing furnace problems.

Your satisfaction is important to our team. That’s why we back our furnace repair* for a year.

How a Low Pressure Switch Works

Pressure switches are an important part of the heating operation.

Here’s how your furnace works after the thermostat initiates the call for heat:

  • Your furnace’s control board begins the draft inducer blower motor. This exhausts combustion gases from the heat exchanger and sucks in new gas and air so the burners can ignite.
  • When the pressure switch senses that a suitable amount of air is being brought into the burners, it closes and signals the control board to ignite the furnace.
  • Your furnace ignites and heats your home.

A two-stage furnace has a few pressure switches, which permit it to run at different speeds—and be more efficient.

What Happens When a Low Pressure Switch Acts Up

The low pressure switch may be open for several reasons.

There could be a:

  • Obstructed vent
  • Clogged condensate drain
  • Cracked hose

There could also be a problem with the switch itself, the inducer or the circuit board.

Your furnace will show you there’s something wrong with a red flash from its indicator light, which it uses to feature error codes. It has this red light to flash code, like Morse code.

You might observe fast flashes or an alternating slow flash as it replays a fault code.

Estimated Repair Cost for Furnace Error Code 223

The price to fix your furnace depends on the issue it has and the hours it takes to remedy it.

Here are the usual replacement costs for several components that could be affected:

  • Pressure switch—$40 to $350
  • Inducer—$600 to $1,500
  • Circuit board—$200 to $600

Call the Experts at Winnipeg Supply Service Experts

When you have to have furnace service, you can trust the professionals at Winnipeg Supply Service Experts to take care of the fault code and get your heat moving again.

Call us at 204-800-0613 or schedule an appointment online today.

chat now widget box